Hall Effect Sensor: Service and Repair

Removing And Installing Hall Sender

Preliminary work
1. Remove intake-air distributor.

Removing hall sender

NOTE:
- The hall sensors are located behind the camshaft housing and point towards the intake system.
- Replace all seals and O-rings.

1. Disconnect connector on hall sender. To do so, push the button and remove.
2. Loosen the fastening screw on the hall sender. Use a socket wrench with 1/4 inch drive and a joint.







3. Pull the hall sender out of the camshaft housing.

Installing hall sender
1. Push the hall sender into the camshaft housing and tighten the fastening screw. Tightening torque: 7.5 ftlb.







2. Push on electric connector. The connector must engage audibly.

Subsequent work
1. Install intake distributor.