Overhaul

Disassembling And Assembling Cup Holder

Preliminary work

1. Remove cup holder. Refer to Removing and installing cup holder.
2. Remove moulding for dashboard (cup holder). Refer to Removing and installing moulding for dashboard.

Disassembling cup holder

Removing flap

INFORMATION: The flap can be replaced when the vehicle's cup holder is installed or removed.

1. Open cover -1- in -direction of arrow A-.







2. Open linkage lever -2- in -direction of arrow B-.

INFORMATION: Make sure that the torsion spring -3- does not jump out of place.

3. Insert a screwdriver between the linkage lever -1- and flap -2-, unclip it in -direction of arrow A- and remove it from the linkage lever -arrow B-.







Assembling cup holder

Installing flap

INFORMATION: To fit the flap correctly, the torsion spring -3- must be hooked in prior to installation.

1. Position flap -2- on the linkage lever -1- (-arrow A-) and press it in -direction of arrow B- until it locks with an audible click.







2. By carefully folding over the flap - 2-, check that the torsion spring -3- is secured correctly.
3. Close linkage lever -2- until it engages securely -arrows A-.







4. Close cover -1- until it engages securely -arrow B-.

Subsequent work

1. Install moulding for dashboard (cup holder). Refer to Removing and installing moulding for dashboard.
2. Install cup holder. Refer to Removing and installing cup holder.