7201IN Mounting front seat on assembly fixture

WM 7201IN Mounting front seat on assembly fixture

Tools





Tools and materials

Engine transmission repair stand WW-MG 600/v WE 1171

Seat cushion and backrest mount WE 1293

Mounting front seat on assembly fixture

1. Fit seat mounting -1- on the assembly stands -2-.





Fitting seat mounting

2. Adjust the seat mounting.





Adjusting seat mounting

2.1. Loosen locking lever -1- ( -arrow A- ).
2.2. Adjust seat mounting -2- to the relevant width ( -marking B- ) of the seat frame -arrow B-.
2.3. Tighten locking lever -1-.
2.4. Loosen fastening screw -1- and slide locking wedge -2- as far as the outer edge of the seat mounting -3- ( -arrow A- ).





Adjusting locks

2.5. Tighten fastening screw -1-.
2.6. Slide locking lever -4- as far as the outer edge of the seat mounting -3- ( -arrow B- ).
3. Fit front seat.





Fitting front seat

3.1. Position the front seat -1- on the seat mounting -2-.
3.2. Slide the seat frame as far as it will go into the locking wedge -3- ( -arrow A- ).
3.3. Slide locking lever -4- into the seat frame -arrow B- and lock it -arrow C-.

Information

The preload on the locking lever can be increased or reduced by turning the adjusting screw -5-.