Removing and Installing Door Warning Light

Removing And Installing Door Warning Light

Removing door warning light

CAUTION: Danger of damage to property if bulbs are used or handled incorrectly.
- Risk of damage to bulbs and bulb housing.

- Switch off ignition and remove ignition key.
- To prevent short circuits, the load in question must be switched off while changing bulbs.
- Only bulbs specified in the bulb table may be used.
- Bulbs with a higher wattage may damage the bulb housing.
- New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing bulbs.
- In certain states, it is compulsory to carry spare light bulbs.












1. Push door warning light carefully out of the door trim via the cutaway -arrow- using a screwdriver.
2. Pull off door warning light connector and remove light.

Removing bulb for door warning light







1. Remove bulb socket from the door warning light and remove defective bulb.

Installing bulb for door warning light

INFORMATION: Only use the relevant bulb specified in the bulb table.







1. Insert new bulb in the bulb socket and insert the socket into the door warning light opening.

Installing door warning light












1. Push connector on to door warning light.
2. Press door warning light into door trim panel.