Installing Wiring Harness For Door

Removing and Installing Wiring Harness For Door

Installing wiring harness for door







INFORMATION:
- The wire harness for door spare parts scope means the scope for fully-equipped vehicles. Depending on the vehicle equipment, connectors not required are tied to the wire harness for door using tie-wraps.
- When doing this, ensure the lines are routed correctly so that no line becomes trapped or damaged.







1. Route wire harness for door. Fit both rubber sleeves -arrows A- and clip in the wire harness for door using the five retaining clips -arrows B-.







2. Connect connector on bass loudspeaker until the connector engages securely.
3. Install door sub-frame.

Locking wire harness for door (driver's side) at the A-pillar












1. Push wire harness for door -8- through the A-pillar and fit rubber sleeve -8-.







2. Push together wire harness plug connection for door -6- ( -arrow A- ) and lock it -arrow B-.







3. Unclip wire harness plug connection for door -1- at the fuse carrier -2-.

Locking wire harness for door (passenger's side) at the A-pillar












1. Push wire harness for door through the A-pillar and fit rubber sleeve.







2. Push together wire harness plug connection for door -arrow A- and lock it -arrow B-.







3. Engage wire harness plug connection for door on the body.

Installing side footwell trim on driver's side












1. Insert footwell trim panel -3- ( -arrow A- ) and screw down with the three fastening screws -2-.
- Tightening torque: 3 Nm (2 ftlb.)

2. Insert the fuse carrier cover -1- with both clips -4- into the lateral footwell trim panel -2- and clip in -arrow B-.

Installing side footwell trim on passenger's side












1. Position footwell trim panel -3- ( -arrow A- ) and screw down with both plastic nuts -2-.
2. Fasten carpet -1- at the bottom in the area of the A-pillar -arrow B- using double-sided adhesive tape or suitable adhesive.

Installing wire harness for door trim panel

INFORMATION:
- The wire harness for door trim panel spare parts scope means the scope for fully-equipped vehicles. Depending on the vehicle equipment, connectors not required are tied to the wire harness for door trim panel using tie-wraps.
- When doing this, ensure the lines are routed correctly so that no line becomes trapped or damaged.












1. Insert wire harness into the clips on the door trim panel in -direction of arrow-.
2. Clip connector on plug connection for wire harness for door trim panel to door wire harness into the door trim panel -arrow A-.
3. Push connector onto the door warning light -7-.
4. Plug in connector on switch for memory seat adjustment -4- until it engages securely.
5. Plug in connector on midrange loudspeaker -3- until it engages securely.
6. Plug in connector on switch for power windows -2- until it engages securely.

Subsequent work

Subsequent work for wire harness for door
1. Install head airbag.
2. Install power window motor.
3. Install door trim panel.
4. Connect the battery and carry out "Work instructions after disconnecting the battery".

Subsequent work for wire harness for door trim panel
1. Install door trim panel.
2. Connect the battery and carry out "Work instructions after disconnecting the battery".