708719 Removing and installing trim panel for rear lid

WM 708719 Removing and installing trim panel for rear lid

Technical values





Removing trim panel for rear lid

Removing luggage compartment light in rear lid

1. Switch off ignition and remove ignition key.
2. Use a plastic spatula or screwdriver to prise out the light in the trim panel of the rear lid.





Unclipping light

3. Pull out light, then release and remove connector -A-.

Removing lining for rear lid

1. Unclip cover for rear lock upper part -1- and remove.





Removing cover for rear lock upper part

2. Unclip finger plate caps -1-.





Loosening trim panel

3. Undo fastening screws -2-.

Information

- To reduce the unclipping forces and thereby the risk of damage during removal, the removal steps must be carried out at the accessible connection points using a suitable tool.

4. Unclip lining for rear lid -1-.





Removing trim panel

5. Check clamps -2- , and replace if necessary.

Installing trim panel for rear lid

Installing lining for rear lid

Information

Remove wire harness for luggage compartment light through the opening of the trim panel.

1. Position lining for rear lid -1- on the lid -2- and press in until the clamps -3- engage.





Installing trim panel

2. Tighten fastening screws -2-. => Tightening torque: 3.4 Nm (2.5 ftlb.)





Securing trim panel

3. Press in finger plate caps -1-.
4. Insert cover for rear lock upper part -1- and press in.





Installing cover for rear lock upper part

Installing luggage compartment light in rear lid

1. Push in plug until it is felt to engage.





Connecting plug connection for light

2. Insert light into opening and clip it into the trim panel. Check that light is fitted securely.