703119 Removing and installing rear panel trim
WM 703119 Removing and installing rear panel trim
Technical values
Preliminary work
Remove trim panel for convertible top rest/engine compartment lid. -> 700819 Removing and installing trim panel for convertible top rest - section on "Removing" Service and Repair
Removing rear panel trim
Removing retaining strip for securing luggage
Installation position of retaining strip for securing luggage
1. Move front seat fully forward.
2. Remove covers -1- and push them inwards.
Removing clip
3. Unscrew fastening screws -2- and remove clip -3-.
4. Unscrew fastening screw -1- and remove retaining strip for securing luggage -2- upwards.
Removing retaining strip
5. Check clamp -3- , replace if necessary.
Removing rear wall trim panel
Installation position for rear wall trim panel
1. Loosen rear wall trim panel -1- at the sides from the side trim panel -Arrow A- and lift up and out -Arrow B-.
Removing rear wall trim panel
Installing rear panel trim
Installing rear wall trim panel
Installation position for rear wall trim panel
1. Position rear wall trim panel -1- -Arrow A- and insert sides between the body and side trim panel -Arrow B-.
Installing rear wall trim panel
Installing retaining strip sound absorber for luggage retainer
Installation position of retaining strip for luggage retainer
Information
The fastening points must remain accessible when positioning the sound absorbers (insulation).
1. Pull off protective film and stick retaining strip sound absorbers for luggage retainer -1- to the retaining strip -2-.
Installing retaining strip sound absorber for luggage retainer
Installing retaining strip for securing luggage
Installation position of retaining strip for securing luggage
1. Position retaining strip for securing luggage -2- on the body and press in until the clamps engage.
Installing retaining strip
2. Tighten fastening screw -1-. => Tightening torque: 1.5 Nm (1.0 ftlb.)
3. Position clip -1- and screw down with the fastening screws -2-. torque => Tightening torque: 23 Nm (17 ftlb.)
Installing clip
4. Press in covers -3-.
Subsequent work
Install trim panel for convertible top rest/engine compartment lid. -> 700819 Removing and installing trim panel for convertible top rest - section on "Installing" Service and Repair