72871900 Removing and installing motor for seat adjustment

WM 728719 Removing and installing motor for seat adjustment

Preliminary work

Remove front seat. -> 720119 Removing and installing front seat - section on "Removing" 720119 Removing and Installing Front Seat

Removing motor for seat adjustment





Installation position of motor for seat adjustment

1. Unclip sleeve of long drive shaft -2- of seat adjustment motor -1- at the support.





Unclipping sleeve of shaft of seat adjustment motor

2. Press motor for seat adjustment -1- out of the support -2- at the boot -arrow A-.





Pressing motor for seat adjustment out of support

3. Pull motor for seat adjustment -1- off the short drive shaft -arrow B-.
4. Pull motor for seat adjustment -1- forward under the support -2- ( -arrow C- ) and pull off connector -3- ( -arrow D- ).
5. Pull motor for seat adjustment -1- and sleeve off the long drive shaft -2- ( -arrow A- ).





Pulling motor for seat adjustment off the drive shaft

6. Pull the long drive shaft -2- out of the gear mount -arrow B- and check for damage.
7. Pull the short drive shaft -1- out of the gear mount -2- and check for damage.





Removing drive shaft

Installing motor for seat adjustment

1. Insert the short drive shaft -1- into the gear mount -2- by twisting slightly.





Installing drive shaft

2. Insert the long drive shaft -2- into the gear mount -arrow A- by twisting slightly.





Pushing motor for seat adjustment onto the drive shaft

Information

When installing the motor for seat adjustment, make sure the two seat rails are in the same position.

3. Push motor for seat adjustment -1- and sleeve onto the long drive shaft -2- by twisting slightly -arrow A-.
4. Attach the connector -3- to the motor for seat adjustment -1- ( -arrow A- ) until it engages firmly.





Pressing motor for seat adjustment into support

5. Push motor for seat adjustment -1- under the support -2- ( -arrow B- ).

Information

When installing the motor for seat adjustment, make sure the two seat rails are in the same position.

6. Push motor for seat adjustment -1- onto the short drive shaft by twisting slightly -arrow C-.
7. Press motor for seat adjustment -1- into the support -2- at the boot -arrow D-.
8. Clip in sleeve of long drive shaft -2- of seat adjustment motor -1- on the support.





Clipping in sleeve of shaft of seat adjustment motor

Subsequent work

Install front seat. -> 720119 Removing and installing front seat - section on "Installing" 720119 Removing and Installing Front Seat