30560150 Checking clutch plate for wear

WM 305601 Checking clutch plate for wear

Preliminary work

1. Remove clutch. -> 305019 Removing and installing clutch - section on "Removing" 30501950 Removing and installing clutch


Checking clutch plate for wear

Information

It should be noted that the clutch lining does not wear linearly over the service life of the clutch. Due to the settling behaviour of the clutch lining, wear can be expected to be greater at the beginning. However, pad thickness wear will become less as mileage increases.

Information

Pad thickness measurement must only be done on the flanged side of the rivet head.

1. Place a commercially available depth gauge on the clutch lining -1- and measure the distance to the rivet head.





Measuring lining thickness

The wear dimension -X- measures 0.3 mm. If a smaller value is measured, the clutch drive plate must be replaced. When new the measured value is more than 1mm.





Sectional view

Subsequent work

1. Install clutch. -> 303019 Removing and installing clutch slave cylinder - section on "Installing" 30301900 Removing and installing clutch slave cylinder - 6-speed transmission