System Specifications
WM 1001TW Technical data, engineTechnical values
Cylinder head
Screw in twelve M10 Torx screws evenly and tighten.
Tightening sequence for cylinder-head screws
Camshaft housing
Camshaft housing to cylinder head
M6
Tightening torque 10 Nm (7.5 ftlb.)
Gear Carrier
Position 14 M9 x 127 thrust-bearing screws manually. Pre-tighten screws to the required tightening torque in accordance with the tightening sequence. Then tighten to the required torque angle.
Initial tightening 15 Nm (11 ftlb.)
Torque angle 120°
Tightening sequence for gear carrier
Connecting rod bolt
Belt pulley
Tightening torque 37 ftlb.
Torque angle 90°
Drive plate for converter
Tighten fastening screws in diagonally opposite sequence.
Flywheel
Tighten fastening screws in diagonally opposite sequence.
Drive plate for converter
Tighten fastening screws in diagonally opposite sequence.
Oil Pump Housing
Exhaust manifold
Fit exhaust manifold with new screws M8 x 26. Tighten screws from the inside out and in diametrically opposite sequence.
Tightening torque 23 Nm (17 ftlb.)
Coolant pump
