Removing and Installing Cover For Centre Underbody

519319 Removing And Installing Cover For Centre Underbody






Preliminary work
Lift the vehicle.

Removing cover for centre underbody






NOTE: Fastening nuts cannot be used again following removal.

1. Unscrew fastening screws -2- and fastening nuts -3-.






2. Pull cover for side underbody -1- out of the overlaps.

Removing cover for centre underbody






NOTE: Fastening nuts cannot be used again following removal.

1. Unscrew fastening nuts -3-.






2. Press covers for side underbody -1- downward slightly and remove cover for centre underbody -4- from the overlaps.

Installing cover for centre underbody






NOTE: When sliding in the underbody trim panel, make sure the overlap is correct.

1. Insert cover for centre underbody -4-, while doing this, press cover for side underbody -1- slightly downward.






2. Tightening fastening nuts -3-.

Tightening torque: 1.5 ftlb.

Installing cover for side underbody






NOTE: When sliding in the underbody trim panel, make sure the overlap is correct.

1. Insert cover for side underbody -1-.






2. Tightening fastening screw -2-.

Tightening torque: 1.5 ftlb.

3. Tightening fastening nuts -3-.

Tightening torque: 1.5 ftlb.

Subsequent work

Reworking
Lower the vehicle.