667919 Removing and installing housing for rear-view mirror

WM 667919 Removing and installing housing for rear-view mirror

Preliminary work

1. Remove mirror adjusting motor. -> 66821900 Removing and installing mirror adjusting motor - section on "Removing" Service and Repair

Removing housing for rear-view mirror

1. Unscrew fastening screws -1- and remove plate -2- from mirror base -3- ( -arrow- ).





Removing plate

2. Remove mirror housing.





Loosening mirror housing

2.1. Unscrew fastening screws -1- at mirror housing -2- ( -arrow- ).
2.2. Pull mirror housing -1- and cover -2- out of mirror base -3- slightly -arrow A-.





Removing mirror housing

2.3. Carefully release cover -2- at locking lugs -arrows B- and unclip from mirror housing -1-.
2.4. Pull mirror housing -1- out of mirror base -3- ( -arrow C- ).
3. Pull cover -1- out of mirror base -2- ( -arrow- ).





Removing cover

Installing housing for rear-view mirror

1. Insert wire harness -3- through cover -1- and slide cover into mirror base -2- ( -arrow- ).





Installing cover

2. Install mirror housing.





Installing mirror housing

2.1. Insert mirror housing -1- into mirror base -3- ( -arrow A- ).
2.2. Clip in mirror housing -1- with cover -2- ( -arrows B- ) until it locks with an audible click.
2.3. Completely insert mirror housing -1- and cover -2- into mirror base -3- ( -arrow C- ).
2.4. Secure mirror housing -2- using the fastening screws -1- ( -arrow- ).





Securing mirror housing

3. Position plate -2- on mirror base -3- ( -arrow- ) and secure using the fastening screws -1-.





Installing plate

Subsequent work

1. Install mirror adjusting motor. -> 66821900 Removing and installing mirror adjusting motor - section on "Installing" Service and Repair