6412IN Processing of Porsche 2-component window bonding agents

WM 6412IN Processing of Porsche 2-component window bonding agents

Tools





Tools and materials

Tools and materials for installing car windows













Pre-treatment of bonding surfaces

Pre-treating adhesive flanges on vehicle windows

Information

- The table below shows how to use cleaners, primers and activators when preparing the adhesive surface.





Pre-treating adhesive flanges on vehicle body

Information

- The table below shows how to use cleaners, primers and activators when preparing the adhesive surface.





Handling processing device

Double cartridge press

CAUTION

Danger of poisoning and injury when handling adhesive!

- Danger of poisoning from breathing in vapours or from swallowing adhesive.
- Risk of injury due to contact with skin or eyes.

-> Ventilate the work area well.
-> Do not eat, drink, or smoke while carrying out work.
-> Avoid direct contact with eyes and skin. Wear suitable protective equipment, such as protective clothing, gloves, and if necessary, a protective mask.
-> If clothing is soiled with adhesive, change clothing immediately and only use again after they have been cleaned.
-> Also observe the product-specific processing and safety instructions on the packing container and packing container imprints.
-> In case of eye contact: Rinse eyes immediately and thoroughly with lukewarm running water and consult an eye doctor.
-> In case of skin contact: Rinse contacted skin areas immediately with lukewarm running water and soap.
-> If adhesive is swallowed: Rinse mouth and consult a doctor.

Information

- In addition to this manual, observe the relevant job descriptions for installing car windows!

1. Preparing cartridge components A and B
1.1. Pierce the membrane in the nozzle connection of components A and B (aluminium cartridge) -H5, H6- with a screwdriver and extend the opening.
1.2. Remove flanged cover on end of cartridge.





2. Screw on mixing nozzle.
2.1. Screw both cartridges -H5, H6- onto the mixing nozzle.





3. Placing cartridges in the double cartridge gun
3.1. Move pressure piston back fully.
3.2. Insert the double cartridges -H5, H6- into the bonding gun -A-.





4. Press out the adhesive
4.1. By activating the valve -arrow- allow the pressure piston to move out slowly until both components of the adhesive are visible at the mixing nozzle.
4.2. Wipe off the emerging adhesive.





5. Screwing on processing nozzle
5.1. Screw processing nozzle -H8- onto the mixing nozzle -H7-.





6. Align processing nozzle
6.1. Turn the processing nozzle on the mixing nozzle until the illustrated position is reached.





7. Mixing adhesive components
7.1. By activating the valve -arrow- allow the pressure piston to move out slowly until the adhesive is visible in the processing pipe.

Information

In this position, when the mixing nozzle is horizontal, the closed surfaces must be visible on the processing nozzle from above and below and the mixer insert's mixing plates must be visible from the sides.





8. Affixing car window

Information

- The bonding material has an open time of 15 min, which means that the bonding material must be applied and the car window must be assembled within this period of time.

- In order to ensure that the substance is completely mixed, apply a 30 mm long adhesive bead of fresh adhesive to a piece of cardboard before processing.