665019 Removing and Fitting Rear Logo

WM 665019 Removing and fitting rear logo

Tools





Technical values






Tools and materials

Hot-air gun v.a.g 1416

Removing rear logo





1. Heat the rear lid
1.1. Heat rear lid in area of the logo using the hot-air gun v.a.g 1416.





2. Lift up the logo using a plastic spatula
2.1. Move a plastic spatula under the logo and lift it up.





3. Clean the rear lid
3.1. Dissolve the adhesive residue on the cover using a silicone remover and remove it.






Fitting rear logo





Information

- Carefully clean any dirt, grease, wax and other impurities off the fitting area of the body using isopropanol.

- Always use a clean cloth.

- The room and object temperature must be at least => Temperature: +18°C.

- Do not touch the adhesive surface again after removing the protective paper.

- Press on the logo in the bonding area with a rubber roller using as much pressure as possible.

- The parts must be allowed to bond for at least 24 hours before washing the vehicle.

1. Mark the centre of the lid





1.1. Affix a strip of adhesive tape measuring -A- , which can be written on, approximately in the centre of the lid and parallel to the edge of the lid.=> Dimension: 85 mm+/-1 mm





1.2. Determine the centre between the outer edges of the lid and mark this on the strip of adhesive tape.





2. Clean bonding area with isopropanol.
3. Pull off protective film





4. Stick on the logo.
4.1. Align the logo according to the marking on the adhesive tape and press it on firmly.





5. Pull the adhesive tape off the rear lid.

Additional notes on fitting

Notes on fitting the logo

Information

- For exact positioning, additional markings must be made on the rear lid.

- The model-specific dimensions are shown in the following drawings.