Removing and Installing Moulding For Dashboard

Removing And Installing Moulding For Dashboard

Preliminary work

Preliminary work for removing moulding for dashboard on passenger's side

Remove cup holder in dashboard.

Information

Component information







Removing moulding for dashboard

Removing moulding for dashboard on driver's side (left)







1. Insert a plastic wedge under the moulding, unclip it carefully and remove it inwards.







2. Disconnect electric plug connection for the temperature starter switch light.

Removing moulding for dashboard on driver's side (right)







1. Insert a plastic wedge under the moulding, unclip it carefully and remove it towards the rear.







2. Disconnect electric connector for the temperature sensor.

Removing moulding for cup holder at the front left and right







1. Insert a screwdriver between the cup holder -7- and left -3- and right moulding -5- .
2. Carefully unclip moulding at the left and right.

Removing moulding for cup holder at the front centre







1. Insert a screwdriver between the cup holder -7- and centre moulding -4- .
2. Carefully unclip centre moulding.

Removing insert with moulding for dashboard on passenger's side

INFORMATION: Only installed in vehicles without a cup holder. The insert with moulding can only be removed as a complete unit.







1. Vehicles without cup holder: Remove insert with moulding -6- .

Installing moulding for dashboard

Installing moulding for dashboard on driver's side (left)







1. Plug in electric plug connection for the ignition starter switch light.







2. Position moulding on the dashboard and clip it in until it engages securely.

Installing moulding for dashboard on driver's side (right)







1. Plug in electric plug connection for the temperature sensor.







2. Position moulding on the dashboard and clip it in until it engages securely.

Installing moulding for cup holder at the front left and right







1. Position left -3- and right moulding -5- on the cup holder -7- .
2. Clip in moulding at the left and right until they engage securely.

Installing moulding for cup holder at the front centre







1. Position centre moulding -4- on the cup holder -7- .
2. Clip in centre moulding -4- until it engages securely.

Installing insert with moulding for dashboard on passenger's side

INFORMATION: Only installed in vehicles without a cup holder. The insert with moulding can only be installed as a complete unit.







1. Fit insert with moulding -6- into the guide.
2. Press moulding and insert -6- in until it engages securely.

Subsequent work

Subsequent work for installing moulding for dashboard on passenger's side

Install cup holder in dashboard.