586319 Removing and Installing Rubber Seal for Rear Door
WM 586319 Removing and installing rubber seal for rear door
Preliminary work
1. Remove B-pillar trim panel. -> 706719 Removing and installing B-pillar trim panel - section on "Removing" 70671901 Removing and installing upper part of B-pillar trim panel 70671903 Removing and installing lower part of B-pillar trim panel
2. Remove C-pillar trim. -> 706819 Removing and installing C-pillar trim - section on "Removing" 706819 Removing and installing C-pillar trim
3. Remove front grab handles. -> 683519 Removing and installing grab handle - section on "Removing" 683519 Removing and Installing Front Handle
4. Remove rear grab handle. -> 683719 Removing and installing rear grab handle - section on "Removing" 683719 Removing and Installing Rear Handle
Removing rubber seal for rear door
Installation position of rubber seal for rear door
1. Detach the headliner. -> 708419 Removing and installing headliner - section on "Removing" 708419 Removing and installing roof trim panel
1.1. Unscrew fastening screws on headliner.
1.2. Unclip headliner from the fastening clips close to the sliding roof cut-out.
2. Remove rubber seal.
2.1. Pull off rubber seal all around the sheetmetal flange.
Pulling off rubber seal
Installing rubber seal for rear door
1. Install rubber seal.
1.1. Fit vulcanisation point of rubber seal -1- close to the door arrester -2- on the sheetmetal flange.
Fitting rubber seal
1.2. The air vents in the rubber seal must be facing the outside of the vehicle.
1.3. Press rubber seal onto the sheetmetal flange all the way around.
2. Check that the seal is installed correctly.
2.1. Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.
2.2. Check the air vents; they must not be closed or covered.
3. Secure the headliner. -> 708419 Removing and installing headliner - section on "Installing" 708419 Removing and installing roof trim panel.
3.1. Clip the headliner in at the fixing clips close to the sliding roof cut-out.
3.2. Screw in fastening screws on the front roof trim panel.
Subsequent work
1. Install front grab handle. -> 683519 Removing and installing front grab handle - section on "Installing" 683519 Removing and Installing Front Handle
2. Install rear grab handle. -> 683719 Removing and installing rear grab handle - section on "Installing" 683719 Removing and Installing Rear Handle
3. Install C-pillar trim. -> 706819 Removing and installing C-pillar trim - section on "Installing" 706819 Removing and installing C-pillar trim
4. Install B-pillar trim. -> 706719 Removing and installing B-pillar trim - section on "Installing" 70671901 Removing and installing upper part of B-pillar trim panel 70671903 Removing and installing lower part of B-pillar trim panel