Camshaft Position Sensor: Service and Repair

WM 283919 Removing and installing hall sender

Preliminary work

1. Remove design cover on cylinder head cover for the affected cylinder bank. -> 108319 Removing and installing engine cover (design cover) Service and Repair





Engine design cover





Removing hall sender

1. Release and unplug connector for camshaft hall sender. => Camshaft hall sender connector





Camshaft hall sender connector

2. Remove fastening screw -3- on hall sender and pull hall sender -4- out carefully.





Valve cover seals, cylinders 1 to 4









Valve cover seals, cylinders 5 to 8





Installing hall sender

Information

The tightening specifications for the basic engine are stored centrally. -> 1001IN Tightening torques, tightening sequences, assembly overviews [1][2]Specifications. Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

1. Replace sealing ring.
2. Carefully fit the hall sender -4-. Fit fastening screw -3- on the hall sender.





Valve cover seals, cylinders 1 to 4









Valve cover seals, cylinders 5 to 8





3. Slide on cable plug. The connector must engage audibly.





Camshaft hall sender connector

Subsequent work

1. Fit design cover for cylinder head cover. -> 108319 Removing and installing engine cover (design cover) Service and Repair





Engine design cover