Removing and Installing Control Unit For Rear-Differential Lock

Removing and installing control unit for rear-differential lock





Preliminary work

Preliminary work for control unit for rear-differential lock

Information
No values (data) are read or written when replacing the rear-differential lock control unit.

The rear-differential lock control unit is only removed and installed again.

The rear-differential lock control unit is not listed in PIWIS Tester II 9818.

1. Partially detach side trim panel for rear left luggage compartment and fold the panel forwards.

Removing control unit for rear-differential lock

NOTICE
Voltage peaks
* Risk of damage to load or to the control unit

-> Remove the ignition key and switch off load before disconnecting or removing load.





Installation position

1. Release, open and disengage the retaining bar.





Removing retaining bar

2. Lift the control unit from the holder and pull it down and out of the holder.
3. Release latch on connector -a- and pull off connector.





Removing connector

4. Remove the control unit.

Installing control unit for rear-differential lock

1. Push electric connector onto the control unit for rear-differential lock and lock connector.
2. Insert control unit for rear-differential lock into the holder and secure using the retaining bar.





Installing control unit for rear-differential lock

Subsequent work

Subsequent work for control unit for rear-differential lock

1. Secure side trim panel for rear left luggage compartment.