644019 Removing and installing front door window
WM 644019 Removing and installing front door window
Technical values
Preliminary work
1. Remove front door sub-frame. -> 573019 Removing and installing front door sub-frame - section on "Removing" 573019 Removing and Installing Front Door Sub-Frame
2. Remove front window regulator motor. -> 645419 Removing and installing window regulator motor - section on "Removing" Service and Repair
Removing front door window
Installation position of front door window
1. Slide the door window glass to its lower end position.
Moving door window to its lower end position
2. Loosen the door window glass.
Loosening door window glass
2.1. Unscrew the fastening screw -1-.
2.2. Lift the door window glass off the power windows mounting.
3. Guide the door window glass out of the window guide and remove it.
Removing door window glass
Installing front door window
1. Insert the door window glass into the guide -2-.
Inserting door window glass into the guide
Insert the door window glass into the power windows mounting.
2. Align the catches for the door window mounting.
Aligning door window glass
2.1. Roll the door window up fully.
2.2. Align the door window until it is parallel with the B-pillar trim and corner window pane -A-.
2.3. Check that the catches are adjusted without tension and re-adjust them if necessary -B-.
3. Screw in fastening screw -1- => Tightening torque: 3.5 Nm (2.5 ftlb.).
Securing door window
Information
- The door window in the door in question must be closed in order to install the door sub-frame.
- Close the window manually before installing the window regulator motor.
4. Install front window regulator motor. -> 645419 Removing and installing window regulator motor - section on "Installing" Service and Repair
5. Install door sub-frame. -> 573019 Removing and installing front door sub-frame - section on "Installing" 573019 Removing and Installing Front Door Sub-Frame
6. Adjust the front door window (final stop). -> 644015 Adjusting front door window Adjustments