Lock Barrel
TO REMOVE1. Remove the gear lever housing, refer to "To remove the gear lever housing with ignition switch". Service and Repair
2. Turn the ignition key to a position roughly mid-way between the locked and garage positions.
3. When the key is in this position, the lock barrel pin can be pressed in with a suitable rod inserted through a hole under the gear lever housing (see figure).
4. Remove the lock barrel.
TO FIT
1. Turn the key in the lock barrel to a position roughly mid-way between the locked and garage positions.
2. Press in the lock barrel pin. Check that the toothed segment driver pins are in the correct position in relation to the lock barrel slot. Push in the lock barrel and check that it is in engagement with the toothed segment.
3. Fit the gear lever housing. Refer to "To fit the ignition switch and gear lever housing". Service and Repair