Programming Main Instrument Display Panel 2
Programming main instrument display panel 2It is possible to program main instrument display panel 2 by means of an Intellegent Saab Tester (ISAT) Scan Tool. During programming, the Scan Tool does not show how the instrument is programmed and the procedure described cannot therefore be used to check this. The main instrument display panel must be programmed in connection with replacement of the processor card or the complete unit.
Important: Before you start programming it is advisable to make a note of the odometer's unit of measurement (km or miles), engine version, tire size and odometer reading. These details are needed for programming the main instrument display panel.
ISAT SCAN TOOL DISPLAY 1
MAIN INSTRUMENT 2
ADJUSTMENT
=>PROGRAMMING
READ SYSTEM INFO
1 Select PROGRAMMING in the Scan Tool's MAIN INSTRUMENT 2 menu.
ISAT SCAN TOOL DISPLAY 2
PROGRAMMING A NEW
MAIN INSTRUMENT
F1=CONTINUE
ESC=END
2 Proceed to the programming phase with F1 or end with ESC.
ISAT SCAN TOOL DISPLAY 3
SELECT TYPE OF
INSTRUMENT
KM INSTRUMENT
SELECT
3 State whether the instrument is to use km or miles as the unit of measurement. Select using F3 or F4.
ISAT SCAN TOOL DISPLAY 4
SELECT TYPE OF
ENGINE
xxxx
SELECT
4 State type of engine, may be B258 (V6), B206- 234-204l (4-cyl) or B204L (turbo).
Select using F3 or F4.
ISAT SCAN TOOL DISPLAY 4a
SELECT TYPE OF
TRANSMISSION
MANUAL/AUTOMATIC
4a If engine type B204L (turbo) was selected, 2 additional choices must be made in displays 4a and 4b.
State the type of gearbox.
Select using F3 or F4.
ISAT SCAN TOOL DISPLAY 4b
IS THE CAR WITH OR
W/OUT HEAT SHIELDS
WITH/WITHOUT
4b If the car is of environmental class 1 type, it is equipped with heat plates. Select using F3 or F4.
ISAT SCAN TOOL DISPLAY 5
SELECT CAR'S
TYRE SIZE
xxxx
SELECT
5 State the car's tire size, may be 185/65,195/60 or 205/50. Select using F3 or F4.
ISAT SCAN TOOL DISPLAY 6
ENTER CAR'S
MILEAGE
XXXXXXXX KM/MILE
6 State odometer reading in previously selected unit of measurement.
Be sure to state the correct reading. It is not possible to program a lower reading than that shown on the odometer.
ISAT SCAN TOOL DISPLAY 7
IS XXXXXXXX KM/MILE
CORRECT
F1 = OK
ESC = END
7 Confirm the entered odometer reading.
ISAT SCAN TOOL DISPLAY 8
PROGRAMMING
WILL NOW OCCUR
F1 = OK
ESC = END
8 Program the instrument with the entered details. This is your last chance to Interrupt programming.
ISAT SCAN TOOL DISPLAY 9
PROGRAMMING
CARRIED OUT
9 This menu confirms that programming has been carried out.
ISAT SCAN TOOL DISPLAY 10
PROGRAMMING
INTERRUPTED
10 This menu is shown if programming was interrupted with ESC.