Instrument Panel Insulator Panel Replacement - Right Side

Instrument Panel Insulator Panel Replacement - Right Side

Removal Procedure




1. Remove the 2 screws that retain the insulator panel to the instrument panel (I/P).
2. Partially remove the insulator panel.
3. Remove the electrical connector retaining clip from the back side of the insulator panel, if equipped.
4. Remove the insulator panel from the vehicle.

Installation Procedure




1. Install the insulator panel to the vehicle, positioning the insulator panel to the I/P.
2. Install the electrical connector retaining clip to the back side of the insulator panel, if equipped.
3. Insert the insulator panel retaining tab into the cowl slot.
4. Seat the insulator panel retaining clip to the I/P substrate.

Notice: Refer to Fastener Notice.

5. Install the 2 insulator panel retaining screws.

Tighten the screws to 2.5 Nm (22 in. lbs.).