Fitting Kit, Anti-theft Alarm, 4D, 5D

Fitting Kit, Anti-theft Alarm, 4D, 5D

Kit components





1. Siren
2. Siren console
3. Bonnet switch
4. Anti-theft alarm sensor
5. Labels
6. Self-adhesive foam plug, dia. 50 mm.

Siren
1. Open the tailgate.
2. 4D: Open the right side hatch in the luggage compartment and remove Sound insulation, luggage compartment right.
5D: Remove right Rear side trim, 5D and Sound insulation, luggage compartment right.





3. Remove the foam plug.
4. Remove the cable ties holding the cables.
5. Insert the cables through the hole.
6. Plug in the connector to the siren.





7. Fit the siren.





8. Tighten the 2 bolts securing the siren.
Tightening torque 4.0 +/- 1.2 Nm
9. Fit the foam plug.





10. 4D: Install Sound insulation, luggage compartment right and close the side hatch.
5D: Install Sound insulation, luggage compartment right and right Rear side trim, 5D.
11. Close the boot lid.

Bonnet switch
1. Open the bonnet.
2. Remove the clip holding the cables.





3. Plug in the connector to the bonnet switch.





4. Fit the bonnet switch.
5. Close the bonnet.

Anti-theft alarm sensor
1. Remove the lens cover from the roof lamp.





2. Remove the switch panel.
3. Remove the connector from its mounting.
4. Connect the connector to the anti-theft alarm sensor.
5. Fit the anti-theft alarm sensor. A click should be heard.





6. Remove the two protective cases from inside the switch panel.
7. Fit the switch panel.





8. Fit the lens protector.
9. Connect the diagnostic tool.
10. Select Add / Remove- Accessories -Theft Alarm and then follow the on-screen instructions.

Anti-theft alarm labels
Affixing anti-theft alarm labels