Procedure After Changing the Control Module

Procedure After Changing The Control Module

SPS programming
Connect Tech2 and use TIS 2000 to check whether the control module requires programming. Go to the "SPS" menu, select "Read control module data" and follow the instructions. This is done so that the control module receives the latest available software and is also adapted to the car variant and market.

Add
Once the control module has been fitted and in certain cases SPS programming has been carried out, Tech2 must be used to marry the control unit to the car. Go to the "All" menu and select the control module under "Add/Remove". Then select "Add" and follow the instructions. The ignition key must be in ON position. TIS 2000 may be required.

The action involves the following:
Properties files are downloaded, security codes are written, bus lists are updated, data in another control modules are updated and fault codes cleared in all control modules.