60. Crankshaft and Bearing Installation

Crankshaft and Bearings Installation

Important: The Powertrain Control Module (PCM) has to perform the crankshaft position learn process under the following conditions:
^ The Crankshaft Position (CKP) sensor is removed for replacement or disassembly
^ The timing belt is removed for replacement or disassembly
^ The CKP Pattern Clear is executed from the Tech II
^ The PCM is replaced





1. Install the pins (107).
2. Lubricate the bearings (104 and 105) and crankshaft bearing surfaces with clean engine oil.
3. Install the upper bearings (105) to the block.
4. Install the crankshaft (102).





5. Install the thrust bearings (104) to number 3 journal.





6. Install the lower bearings (106) and bearing caps (103).





7. Install the bearing caps (103) with the alignment arrow facing the front of the engine.





8. Lubricate the bolt (108 and 109) threads and flanges with clean engine oil.

Notice: Refer to Fastener Notice in Service Precautions.

9. Install the bolts (108 and 109).
9.1. Tighten the bolts (109) in sequence to 74 Nm (54 ft. lbs.).
9.2. Tighten the bolts (108) in sequence to 49 Nm (36 ft. lbs.).
10. Measure the crankshaft end-play.