Instrument Panel (IP) - Trim Bezel Replacement - Center

Trim Bezel Replacement - Center

Removal Procedure





1. Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Console Shift Lever Bezel Replacement) .
2. Remove the I/P storage compartment screws.
3. Remove the storage compartment from the I/P.




4. Starting at the bottom, pull to disengage the trim bezel clips.




5. Disconnect the HVAC control head connections.




6. Disconnect the electrical connectors from the bezel mounted switches.
7. Remove the center trim bezel from the vehicle.



Installation Procedure





1. Position the center trim bezel in the vehicle.
2. Center the temperature cable knob by inserting the alignment tab into the centering slot of the temperature knob shaft.




3. Center the HVAC module temperature door by aligning the cable lug of the temperature control cable with the center point detent spring.




4. Install the temperature cable to the HVAC control head by aligning the snap tabs to the knob shaft and by snapping into place.
5. Connect the other control head connectors.




6. Connect the electrical connectors to the bezel mounted switches.




7. Starting at the top of the bezel, push to engage the trim clips.




8. Position the I/P storage compartment.

Notice: Refer to Fastener Notice in Cautions and Notices.

9. Install the storage compartment screws.

Tighten the screws to 2.5 N.m (22 lb in).

10. Install the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Console Shift Lever Bezel Replacement) .