Accelerator Pedal Position Sensor: Service and Repair

ACCELERATOR PEDAL POSITION (APP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the connector position assurance (CPS) from the accelerator pedal position (APP) sensor connector.
2. Disconnect the APP sensor harness connector.
3. Remove the APP assembly attachment bolts to the brake pedal assembly.

IMPORTANT:
- Due to clearance issues, the upper attachment bolt cannot be removed from the accelerator pedal assembly. Loosen the bolt completely and leave the bolt in the component until the assembly is removed from the vehicle.
- A speed wrench may be used to aid in the removal and installation.




4. Remove the APP assembly from the vehicle.

INSTALLATION PROCEDURE




1. Install the upper attachment bolt into the APP assembly.
2. Install the APP assembly into the vehicle.
3. Install the attachment bolts into the APP assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the accelerator pedal position assembly-to-brake bracket bolt to 25 N.m (18 lb ft).

4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
5. Install the APP sensor connect CPA.