Transmission Temperature Sensor/Switch: Service and Repair

Transmission Fluid Temperature (TFT) Sensor Replacement

Removal Procedure





1. Raise and support the vehicle.
2. Disconnect the wiring harness from the transmission fluid temperature (TFT) sensor.

Important: Do not damage the TFT sensor or transaxle case.

3. Remove the TFT sensor bolt/screw.
4. Remove the TFT sensor and the O-ring.

Installation Procedure





1. Apply automatic transmission fluid to the new TFT sensor O-ring seal.
2. Install the new TFT sensor O-ring seal onto the TFT sensor.
3. Install the TFT sensor into the transmission case assembly.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the TFT sensor bolt.
- Tighten the output speed sensor bolt to 12 Nm (87 inch lbs.).
5. Connect the wiring harness to the TFT sensor.
6. Lower the vehicle.