Trim Plate Replacement - Console

Trim Plate Replacement - Console

Removal Procedure





1. Position the front seats rearward.
2. Reach under the front seats to access the lower console screws.
3. Remove the console screws.




4. Remove the cup holder liner.
5. Remove the cup holder screw.




6. Lift the rear of the center floor console.
7. Disconnect the electrical connector to the auxiliary power outlet.
8. Slide the center floor console rearward.




9. Remove the center trim panel by pulling outward.



Installation Procedure





1. Position the center trim plate to the front console.
2. Push until the trim clips engage.




3. Lift the rear of the center floor console.
4. Connect the electrical connector to the auxiliary power outlet.
5. Reposition the center console.





Notice: Refer to Fastener Notice in Cautions and Notices.

6. Install the cup holder screw.

Tighten the screws to 2.5 N.m (22 lb in).

7. Install the cup holder liner.




8. Reach under the front seats to access the lower console screws.
9. Install the center console screws.

Tighten the screws to 2.5 N.m (22 lb in).

10. Position the front seat forward to the original position.