Brake Pressure Modulator Valve Bracket Replacement

Brake Pressure Modulator Valve Bracket Replacement

Removal Procedure

1. Place the ignition switch in the OFF position.
2. Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement (Underhood Electrical Center or Junction Block Replacement) .




3. Remove the brake pressure modulator valve (BPMV) bolt (1).




4. Without disconnecting the brake pipe fittings, carefully lift the BPMV assembly (1) upward to release the mounting pins from the BPMV bracket insulators.
Do not pry on the accumulator caps on the underside of the BPMV.
5. Position the BPMV assembly aside and secure with heavy mechanics wire or equivalent.




6. Remove the 2 BPMV bracket bolts (1).




7. Remove the BPMV bracket nut (1) and the BPMV bracket.
8. Inspect the insulators for damage and replace, if necessary.



Installation Procedure





1. Install the BPMV bracket.
2. Loosely install the BPMV bracket nut (1).

Notice: Refer to Fastener Notice (Fastener Notice) .





3. Install the 2 BPMV bracket bolts (1).

Tighten the bolts to 10 N.m (89 lb in).

4. Tighten the BPMV bracket nut.

Tighten the nut to 10 N.m (89 lb in).





5. Carefully position the BPMV assembly (1) to the BPMV bracket insulators.




6. Install the BPMV bolt (1).

Tighten the bolt to 10 N.m (89 lb in).

7. Install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement (Underhood Electrical Center or Junction Block Replacement) .