Drive Sprocket, Driven Sprocket, and Drive Link Assemble

Drive Sprocket, Driven Sprocket, and Drive Link Assemble


Tools Required
* J 29569-1 Turbine Shaft Seal Installer
* J 29569-2 Turbine Shaft Seal Sizer
* J 29829-1 Turbine Shaft Seal Installer
* J 29829-2 Turbine Shaft Seal Sizer






1. Assemble the drive sprocket (37) onto the turbine shaft (39).
2. Retain the drive sprocket with the turbine shaft to drive sprocket snap ring (35).




3. In order to assemble three new Teflon seals (33, 40) onto the turbine shaft (39), perform the following procedure:

1. Slide theJ 29569-1 over the large spline of the turbine shaft.
2. Coat theJ 29569-1 with transmission fluid.
3. Use your fingers in order to guide the new Teflon(TM) seals over theJ 29569-1 and into the seal ring grooves on the turbine shaft.
4. Remove theJ 29569-1 when the seals are in place.

Important: In order to properly size the seals, keep theJ 29569-2 in place for 5 minutes.


5. Size the new Teflon(TM) seals. Use both halves of theJ 29569-2 .
6. Repeat steps 3.1 through 3.6 withJ 29829-1 andJ 29829-2 on the small splined side of the turbine shaft.