Transmission Position Sensor/Switch: Adjustments

ADJUSTMENT

Air Induction System:

1. Remove air induction system for access.

Ohmmeter Hook-up:

2. Place transaxle in D (Drive). Use ohmmeter or continuity tester to check for continuity across terminals on switch. Loosen the mounting bolts and rotate the park neutral position switch from the left front fender towards the engine until continuity is achieved.

3. Tighten switch to case bolts. After switch to case bolts have been tightened, check continuity.
- Torque: 14 NM (124 in. lbs)

NOTE: DVM with audible continuity test is preferred. Do not stick probe in terminal hole; use male terminals on switch or faulty readings could exist.

NOTE: While adjusting the park neutral position switch, always rotate the switch towards the engine to achieve continuity. A DTC P0706 could result if this procedure is not followed.

4. Connect electrical connectors.

Air Induction System:

5. Install air induction system.
- Torque: 10 NM (89 in. lbs)