Operation CHARM: Car repair manuals for everyone.
Home >> Saturn >> 1998 >> SW1 L4-1.9L SOHC VIN 8 >> Repair and Diagnosis >> Power and Ground Distribution >> Service and Repair >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation




1. Position new ignition and start switch (P/N 21024682) to ignition module assembly and install two screws and tighten.

Torque: 2-3 N^m (18-27 in-lbs)

2. Connect electrical connector to ignition and start switch.

Ignition Switch: Installation:




3. Position upper and lower steering column shrouds to steering column and install two upper-to-lower steering column shroud screws and three lower steering column shroud-to-steering column screws.
4. Install ignition lock cylinder into ignition module.




5. Route hood release cable through I/P, then install hood release cable to lever.

Ignition Switch: Installation:




6. Install steering column filler panel and Data Link Connector (DLC).
7. Install and torque five screws.

Torque: 2.2 N^m (20 in-lbs)

8. Turn ignition switch to LOCK position and remove key.
9. Enable the SIR system. (Refer to Enabling the SIR System in Diagrams/Diagnostic Aids/General Troubleshooting Procedures/The SIR System.) Diagnostic Aids
pro multis · About Operation CHARM