Removal

Ignition Switch: Removal:

1. Disable the SIR system. (Refer to Disabling the SIR System in Diagrams/Diagnostic Aids/General Troubleshooting Procedures/The SIR System.) Diagnostic Aids
2. Remove two screws holding Data Link Connector (DLC) to filler panels.
3. Remove the five steering column filler panel screws.




4. Remove hood release cable from lever by releasing cable housing, then rotating cable downward to cutout.
5. Remove steering column filler panel.

Ignition Switch: Removal:

6. Remove two upper-to-lower steering column shroud screws and three lower steering column shroud-to-steering column screws.
7. Remove upper steering column shroud.

Ignition Switch: Removal:

8. Insert ignition key into ignition lock cylinder and rotate ignition key to ACC position.
9. Depress the square locking button on the top of the ignition lock cylinder module and slide ignition lock cylinder assembly from ignition lock cylinder.
10. With ignition lock cylinder removed, remove lower steering column shroud.
11. Disconnect ignition and start switch electrical connector.




12. Remove two screws holding ignition and start switch to ignition module assembly, and remove ignition and start switch.