Manifold Pressure/Vacuum Sensor: Service and Repair

REMOVAL
1. Turn ignition Off.
2. Disconnect electrical connector from MAP sensor.
3. Remove attachment nuts for the throttle cable bracket. Pick up and move throttle cable bracket to the side. Remove MAP sensor. Remove port seal if retained in intake manifold.

INSTALLATION
1. Install MAP sensor and port seal into intake manifold.
2. Install throttle cable bracket and nuts.

Torque: 5 N.m (44 in-lbs)

3. Connect electrical connector to the MAP sensor. Push in connector until a click is heard and pull back to confirm a positive engagement.