Ignition Lock Cylinder

REMOVAL




1. Disconnect negative battery cable.
2. Remove lock cylinder bezel from steering column shroud by carefully prying with a thin bladed screwdriver.




3. Remove steering column upper shroud panel.
4. Insert key into ignition lock cylinder and rotate to START position. Then rotate cylinder back to the RUN position.




5. Depress the locking button on the top of ignition module assembly with a thin pick-type tool. Slide lock cylinder assembly from ignition module.

INSTALLATION

IMPORTANT: Actuator blade within ignition module housing must be in the RUN position to install lock cylinder assembly. If rotated, replace it to the RUN position using needle nose pliers.




1. Insert key into ignition lock cylinder and install into ignition module.




2. Install steering column upper shroud.




3. Install lock cylinder bezel.
4. Reconnect negative battery cable.