Removal and Installation

NOTICE:
- If SDM is dropped or shows any sign of damage, it must be replaced.
- Prior to removing SDM, ignition key must be in the OFF position.


REMOVAL

1. Disable the SIR system. (Refer to: Air Bag(s) Arming and Disarming procedures.)
2. Remove console rear screws.
3. Remove console front screws.
4. Lift rear of console.
5. Remove connector position assurance (CPA) retainers and disconnect wire harnesses.
6. Remove nuts and SDM.


INSTALLATION

1. Install SDM and nuts to vehicle.

Torque: 15 Nm. (133 in-lbs)

2. Connect wire harnesses and install CPA retainers.
3. Install console screws.

Torque: 1.2 Nm. (11 in-lbs)

4. Enable the SIR system. Refer to: Air Bag(s) Arming and Disarming