Right Hand Drive Domestic Vehicles Only

REMOVAL





1. Disable the SIR system.
2. On Sedans and Wagons, remove windshield defroster nozzle duct by rotating front of duct up and away from windshield.
On Coupes, windshield defroster nozzle duct cannot be removed because of windshield rake angle. Push windshield defroster duct as far as possible to the passenger side to gain access to the brake pedal.





3. Remove vacuum booster push rod retainer and washer.
4. Remove brake pedal pivot bolt and nut by accessing them through the top of the instrument panel.
5. Remove vacuum booster push rod from brake pedal push rod pin.
6. Remove brake pedal from vehicle.

INSTALLATION





1. Position brake pedal in vehicle.
2. Apply grease to brake pedal push rod pin and place vacuum booster push rod onto pin.
3. Install brake pedal pivot bolt and nut by accessing them through top of instrument panel.
Torque: 22 Nm (16 ft. lbs.)





4. Install vacuum booster push rod retainer and washer.
5. Check and adjust stop lamp switch.




6. On Sedans and Wagons, install windshield defroster nozzle duct into vehicle by snapping windshield defroster nozzle duct onto mode valve assembly and install screws.
On Coupes, move windshield defroster nozzle duct from passenger side and snap windshield defroster nozzle duct onto mode valve assembly and install screws.
7. Enable the SIR System.