A/T - MIL ON/DTC P0711 Set After Flat Towing
BULLETIN NO.: 01-T-28ISSUE DATE: May, 2001
CATEGORY TYPE: Transaxle - 03
CATEGORY: Automatic
CORPORATION NO.: 01-07-30-022
TECHNICAL INFORMATION BULLETIN
SUBJECT:
(MIL) SERVICE ENGINE SOON Telltale Illuminated With DTC P0711 After Vehicle Is Flat-Towed With All Four Wheels On The Ground (Clear DTC and Retest)
MODELS AFFECTED:
1996 - 2002 Saturn S-Series vehicles equipped with automatic transaxle (RPO MP6I/MP7)
CONDITION:
Some customers may comment that the (MIL) SERVICE ENGINE SOON telltale is illuminated after vehicle is flat-towed with all four wheels on the ground.
CAUSE:
While flat-towing a vehicle with all four wheels on the ground, the automatic transaxle fluid temperatures will increase as vehicle is being towed. Starting and driving the vehicle immediately following towing may set DTC P0711-Transaxle fluid temperature (TFT) Sensor Performance.
Refer to this bulletin for specific DTC P0711 information.
CORRECTION:
Follow the procedure in this bulletin to clear DTC P0711. Also, advise the customer of the cause of the DTC being set and explain the importance of correct automatic transaxle fluid level when flat-towing the vehicle with all four wheels on the ground.
Refer the customer to Service Information Bulletin 97-I-19A for comprehensive information on preparing their vehicle for flat-towing.
IMPORTANT:
DTC P0711 cannot be cleared using a scan tool until the TFT sensor passes at least two warm-up cycles.
PROCEDURE:
1. Using a Tech 2, diagnose and clear other DTC(s).
2. Disconnect negative battery cable.
3. Disconnect positive battery cable.
4. Touch and hold battery cable terminals together for 15 seconds.
5. Connect positive battery cable.
Torque:
Battery Terminal Bolts: 17 Nm (13 ft-lbs)
6. Connect negative battery cable.
Torque:
Battery Terminal Bolts: 17 Nm (13 ft-lbs)
7. Using Tech 2, clear DTC P0711 if still existing and/or verify that DTC is cleared and (MIL) SERVICE ENGINE SOON telltale is not illuminated.
DTC P0711 sets when the transaxle fluid temperature (TFT) sensor reading is above a calibrated temperature (below a calibrated voltage) based on IAT temperature when vehicle has been started cold. A cold start is determined when ECT and IAT readings are within a certain temperature of each other. This DTC is a rational check of the TFT sensor.
DTC PARAMETERS
DTC P0711 will set if TFT sensor temperature is greater than 9°C plus IAT sensor temperature when:
^ Vehicle is in a cold soak (ECT and IAT temperature are within +/- 6°C [11 °F] of each other)
^ Condition exists for longer than 2 seconds
^ IAT is less than 40°C (104°F)
^ No ECT, IAT, P0710, P0712, P0713, P0714 DTCs have been set
DTC P0711 diagnostic runs once per ignition cycle once the above conditions have been met.
DTC P0711 is a type A DTC.
DIAGNOSTIC AIDS
IMPORTANT:
If DTC P1635 is also set, diagnose that DTC first. A short to ground/short to voltage on the 5 volt reference circuit may set this DTC.
DTC P0711 indicates a skewed TFT sensor or decreased sensor circuit resistance.
Transaxle fluid leaking from the sensor into the sensor connector will cause a shorted condition across the sensor terminals resulting in an elevated temperature.
DTC P0711 may set if the vehicle is towed with the front or all four wheels on the ground. If this is suspected, clear the DTC and return vehicle to the customer. Refer to this bulletin for Clearing DTC procedure.
CLAIM INFORMATION:
To receive credit for this repair during warranty coverage period submit a claim through the Saturn Dealer System as shown.
DISCLAIMER