Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously

Assembly

ASSEMBLY

1. Using bushing remover/installer KM-906-70, KM-906-33, KM-906-35, and KM-906-34 wedge to press in new damping bushing.

NOTICE: New nut and bolt must be used. Torque retention of old nut and bolt may not be sufficient.

2. Install control arm to rear suspension support using new nut and bolt. Hold the bolt stationary while tightening the nut.
Torque: Rear Suspension Control Arm-to-Rear Suspension Support: 90 Nm (66 ft. lbs.) + 60° - 75°

IMPORTANT: If installing a new crossmember, loosen the nut and bolt and re-torque to specification.

Torque: Crossmember Nut and Bolt: 90 Nm (66 ft. lbs.) + 60° to 75°

3. Install rear suspension support into vehicle.