Gouges

GOUGES

In some cases, the damaged area requires a plastic build-up to establish the original contour of the body. If the SMC is not pierced through, the repair procedure is as follows:
1. Remove all paint from surrounding area by sanding.
2. Scuff sand the area surrounding the damage to provide a good surface.
3. Clean repair area using cleaning solvent.
4. Mix two-part epoxy filler according to manufacturer's instructions.
5. Apply filler using a plastic or rubber squeegee.
6. Allow filler to cure according to manufacturer's directions.
7. Finish the repair by grinding, sanding and painting in the usual manner.