Operation CHARM: Car repair manuals for everyone.
Home >> Saturn >> 2002 >> LW100 L4-2.2L VIN F >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair >> Wheel Speed Signal Conditioner Module
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wheel Speed Signal Conditioner Module

WHEEL SPEED SIGNAL CONDITIONER MODULE

REMOVAL




1. Ignition Off
2. Remove left side lower I/P closeout panel (hush panel) attachment fasteners and remove left side lower I/P closeout panel (hush panel).
3. Remove left side lower heater duct assembly attachment fastener and remove left side lower heater duct assembly.




4. Remove wheel speed signal conditioner module located under left side of I/P above hood release. The module is an orange colored component, which is similar to, but slightly larger than a relay. The module should be removed like a relay.

INSTALLATION
1. Install wheel speed signal conditioner module to I/P harness.
2. Tape or wire tie wheel speed signal conditioner module and its harness to the I/P harness so it does not hang down (if original tape was removed).
3. Install left side lower heater duct and attachment fastener.
4. Install left side lower I/P closeout panel (hush panel) and attachment fasteners.
pro multis · About Operation CHARM