P0130

Schematic:

The Oxygen Sensor 1 (O2S-1) is an electrical source that responds to oxygen content in the exhaust manifold. When the sensor reaches approximately 316 °C (600 °F), it produces a voltage based on the difference in oxygen between the atmosphere and exhaust gas. The PCM sends a bias voltage (391-491 mV) on the signal line which is pulled up through high resistance. When the O2S-1 is cold, it produces no voltage and has extremely high internal resistance. The internal resistance of the sensor is much greater than the resistance of the bias pull-up resistor. However, when the sensor heats up, it produces voltage that overrides the bias voltage. This voltage is read by the PCM to determine a rich/lean O2S-1 signal used to adjust injector pulse width. Under normal conditions, low sensor voltage means high oxygen content/lean air-fuel mixture and vice versa. Normal sensor readings will fluctuate between 10 mV and 999 mV. DTC P0130 sets when the O2S-1 signal is not consistently fluctuating out of the 300-600 mV range necessary for closed loop fuel control.

DTC PARAMETERS
DTC P0130 will set if O2S-1 voltage is not fluctuating outside 300-600 mV when:
^ Condition exists for longer than 49 seconds
^ Engine run time is greater than 1 minute
^ ECT is greater than 60°C (140°F)
^ TP angle is greater than 7%
^ No cam, CKP, ECT, EGR, EVAP purge solenoid, fuel trim, IAT, MAP, misfire, system voltage or TP sensor DTCs have been set.

DTC P0130 diagnostic runs continuously once the above conditions have been met.

DTC P0130 is a type B DTC.

DIAGNOSTIC AIDS
The most probable cause for DTC P0130 is contamination. Check for obvious contamination (oil, fuel or engine coolant) by removing sensor. Identify and correct the cause of the contamination if contaminated. Replace the O2S-1.

IMPORTANT: An intermittent open in the signal or ground wire, as well as an inactive sensor, will not set this DTC.