Center Pillar Garnish Molding Replacement (Sedan/Wagon 2nd Design)

Center Pillar Garnish Molding Replacement (Sedan/Wagon 2nd Design)

Removal Procedure




1. Remove the shoulder belt adjuster knob by unsnapping the locking clip with an awl.
2. Unsnap the shoulder belt bolt cover and remove the bolt.
3. Pull firmly at the clip locations to disengage.
4. Slide the center pillar upper trim up and out to remove.





Important: On sunroof equipped vehicles, ensure that the sunroof wiring is not being pinched.


1. Slide the top tab of the center pillar upper trim underneath the headliner edge and align the clips at the sheet metal hole locations.
2. Press firmly at the clip locations to engage.
3. Slide the center pillar upper trim down slightly to be sure the interlocking tabs at the bottom are properly seated beneath the center pillar lower trim finish panel.





Caution: Apply Loctite 242(R) Threadlocker US P/N 12345382 (Canadian P/N 10953489), or equivalent, on all restraint bolts/nuts before installation. Failure to use such threadlocker correctly may result in personal injury.

4. Install the shoulder belt bolt ensuring the seatbelt webbing is not twisted.

Tighten the front shoulder belt bolt to 50 Nm (37 lb in).

5. Snap the shoulder belt bolt cover.
6. Install the shoulder belt adjuster knob.
7. Check the function of the shoulder belt.