Body Control System Diagnosis
B3031 - Security System Controller In Learn ModeSchematic:
CIRCUIT DESCRIPTION
The passlock sensor is powered by circuit 812. The passlock sensor is grounded by circuit 1057. Passlock sensor data is supplied to the body control module (BCM) by circuit 1836.
The passlock sensor data supplied to the BCM is in the form of V-codes or voltage codes. When the proper ignition key is turned in the ignition switch, the correct V-code is supplied to the BCM. The BCM responds by sending a serial data password to the engine controller allowing the engine to run.
If the BCM has not learned a V-code, DTC B3031 will be set. The vehicle will not start.
DTC PARAMETERS
^ Ignition is in RUN, START or ACC
^ The BCM has not learned a valid V-code
^ Service (wrench) light will illuminate
^ Security light will illuminate
DIAGNOSTIC AIDS
^ Check for poor connection at the BCM. Inspect harness connectors for backed Out terminals, improper terminal mating, broken connector locks, improperly formed or damaged terminals and poor terminal-to-wire connection (terminal crimped over wire insulation and not conductors).
^ Inspect wiring harness for damage. Check for broken or chaffed insulation.
^ If fault is suspected to be intermittent, wiggling harness wiring may help in locating fault.
TEST
Diagnostic Chart Part 1:
Diagnostic Chart Part 2:
