Rear Wheel Speed Sensor

REAR WHEEL SPEED SENSOR

REMOVAL

CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON THE HOIST. TO HELP AVOID PERSONAL INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END FROM WHICH COMPONENTS ARE BEING REMOVED.

1. Raise vehicle on hoist.

2. Disassemble rear brake assembly.

3. Disconnect wheel speed sensor electrical connector.
4. Remove wheel speed sensor bolt.
5. Remove wheel speed sensor.

INSTALLATION
1. Route electrical connector through hole in backing plate and seat wheel speed sensor rubber grommet into backing plate.
2. Install wheel speed sensor into bearing.
Torque:
Rear Wheel Speed Sensor: 8 Nm (71 inch lbs.)

3. Assemble rear brake assembly.

4. Connect rear wheel speed sensor electrical connector.
5. Lower vehicle from hoist.