Center Pillar Garnish Molding - Upper

REMOVAL
1. Unsnap shoulder belt fastener cover.
2. Remove shoulder belt fastener and place shoulder belt on seat.
3. Remove should belt height adjuster button.




4. Remove center pillar garnish molding fastener plug.
5. Remove center pillar garnish molding fastener.
6. Starting at the top, gently pull on center pillar garnish molding to disengage attaching clips.
7. Remove center pillar garnish molding.

INSTALLATION

IMPORTANT: Apply permatex(R) 24200 on all restraint fasteners prior to installation.




1. Position center pillar garnish molding to the vehicle sliding lower tab behind the lower garnish molding.
2. Gently push at clip location to install center pillar garnish molding.
3. Install center pillar upper garnish molding fastener.

Torque:
2.5 N.m (22 in-lbs)

4. Install center pillar garnish plug.
5. Install height adjuster knob.
6. Install shoulder assembly.

Torque:
Shoulder Belt Assembly: 50 N.m (37 ft-lbs)

7. Snap shoulder belt fastener cover closed.