Seat Back Recliner Handle Replacement - Front (Non-Fold Flat)
Driver or Passenger Seat Recliner Handle Replacement (Non-Fold Flat)
Removal Procedure
1. Remove the seat from the vehicle. Refer to Front Seat Replacement - Bucket.
2. Remove the recliner trim by pulling on the trim.
3. Remove the seat riser trim handle by pulling on the handle.
4. Remove the screw from the outer trim panel.
5. Remove the outer trim panel from the seat cushion.
6. Remove the recliner handle bolt and spring. Remove the recliner handle.
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
1. Position the recliner handle to the adjuster with the fastener and the spring. Secure the handle in place with the recliner handle bolt. Tighten the bolt to 10 Nm (89 lb in).
2. Position the outer trim panel to the seat cushion. Secure the trim panel with the screws. Tighten the screws to 2.5 Nm (22 lb in).
3. Install the recliner handle trim.
4. Install the seat riser handle trim.
5. Install the front seat. Refer to Front Seat Replacement - Bucket.