Seat Cushion Outer Trim Panel Replacement - Front Seat (4-Way)

Front Seat Cushion Outer Trim Panel Replacement (4-Way)

Removal Procedure






1. Remove the front seat. Refer to Front Seat Replacement - Bucket.
2. Remove the riser handle trim by pulling firmly on the trim.
3. Remove the recliner handle trim by pulling firmly on the trim.






4. Remove the trim panel screws.
5. Remove the trim panel from the seat.

Installation Procedure

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.






1. Position the outer trim panel on the seat. Secure the panel with the panel screws. Tighten the screws to 2.5 Nm (22 lb in).






2. Position the cover over the recliner handle. Push firmly to lock the handle into place.






3. Position the cover over the seat riser handle. Push firmly to lock the handle into place.
4. Install the front seat. Refer to Front Seat Replacement - Bucket.