Front Wheel Bearing/Hub Assembly
FRONT WHEEL BEARING/HUB ASSEMBLYREMOVAL
1. Remove front brake rotor.
2. Disconnect wheel speed sensor electrical connector, if equipped.
3. Remove the wheel speed sensor electrical connector from the connector bracket.
4. Remove front the front wheel drive shaft spindle nut.
5. Suspend or support drive axle from strut spring with mechanics wire.
6. Remove and discard wheel bearing/hub bolts.
7. Remove wheel bearing/hub assembly and shield.
INSTALLATION
1. Install wheel bearing/hub assembly and shield onto shaft.
2. Install wheel bearing/hub to steering knuckle.
Tighten
Tighten the bolts to 130 N.m (96 ft. lbs.)
3. Install drive axle shaft nut.
Tighten
Tight the nut to 205 N.m (151 ft. lbs.)
4. Install wheel speed sensor electrical connector to bracket, if equipped.
5. Connect wheel speed sensor electrical connector.
6. Install front brake rotor.